Explanation Of Symbols Used - Blaupunkt PG4000 Manual Del Usario

RISKS OF FIRE AND EXPLOSION
When spraying flammable coatings vapours from paint and solvents can cause flammable gases produced in the work area (haz-
ard area). Risks of fire and explosion due to ignition sources in this danger zone. The electrically operated spray device contains
potential ignition sources (spark formation when switching the motor on and off, when inserting and removing the power plug,
due to potential static electricity at the spray gun)
• Device must not be used at operating sites that fall under the explosion protection ordinance.
• Do not use combustible coating substances and cleaning agents
• Always seal paint or solvent containers tightly in the vicinity of the device.
• When cleaning devices with flammable solvents, disconnect the device from the mains and clean thoroughly with a
brush and cloth. Before starting the device up again, ensure that all traces of solvents are removed thoroughly. Allow
the cleaned parts to dry completely.
WARNING: Danger of injury! Never point spray gun at yourself, other persons or animals.
When spraying paint, wear a suitable respirator.
• The user should be supplied with a breathing mask. In order to avoid occupational diseases, the working instructions
provided by the manufacturer of the materials, solvents and cleaning agents used must be complied with during
preparation, working with and cleaning the equipment.
Protective clothing, gloves and, if necessary,protective skin cream is required to protect the skin.
WARNING:
• When working with the paint spraying system both indoors and outdoors, ensure that no solvent-based vapours can
form within the area of the paint spraying system.
WARNING: When working in closed places sufficient ventilation must be ensured to remove the solvent vapours.
•
WARNING: The device is not splash proof. It should not be used, neither outdoors in the rain nor be sprayed with water
•
nor immersed in liquid. Do not use the device in damp or wet environments.
Do not lay the filled spray gun down.
•
• Extraction systems should be installed on-site according to the local regulations.
• The object to be coated must be earthed.
Caution against dangers that can arise from the sprayed substance and observe the text and information on the
•
containers or the specifications given by the substance manufacturer.
Do not spray any liquid of unknown hazard potential.
•
• Before dismounting the spray attachment, relieve pressure by opening the container.
• Before using the device, remove the power plug from the socket.
• Work or repairs on the electrical equipment should only be carried out by a professional electrician, even if there are
instructions regarding such work in the operating instructions. No liability will be accepted for improper installation.

EXPLANATION OF SYMBOLS USED

This symbol indicates a potential danger for you or for the device. Under this symbol you can
find important information on how to avoid injuries and damage to the device.
i
Indicates tips for use and other
particularly useful information.
Refers to the corresponding chapter in the operating manual
and the information presented there relating to the illustration.
Wide spray jet setting
Narrow spray jet setting
EX
5
4
3
2
1
1
1
1
Q
W
ea
ev
Di
Fo
loc
To
T