Starting And Using - Hotpoint Ariston MCA 16/HA Instrucciones De Uso

Starting and using

! Before starting the machine make sure the containers
are filled with the amount described in the manual.
Prime the circuit immediately to prevent damage to the
machine.
! After starting the machine, regulate water hardness.
That will allow you to keep your machine in perfect
order (see Programming).
The first time you switch on
1. Open the front panel
by pressing firmly in the
center.
2. Remove the bean
container.
(to your convenience,
you can take out
complete container and
fill whenever you want
or even changhe the
container with another
one which is filled, for
example, with decaf
coffee).
3. Pour coffee beans
into the container being
careful not to add too
many.
Close the lid and repla-
ce the container inside
the machine.
4. Remove the water
tank fully from the
machine.
when the tank is only half empty caused by the use of
the water filter which soften your water.
! Always use fresh, non-sparkling water to fill the tank.
Hot water or any other liquid may damage the tank
and/or the machine. Do not switch the machine on
without water: make sure that the tank is fully filled
begins to heat up and the display shows:
RINSING
WARMING UP...
When the right temperature is reached, the machine
goes through a rinsing cycle.
RINSING
The machine dispenses water from the brew unit as it
rinses the internal circuits.
After rinsing, the machine returns to normal operating
conditions. The display shows:
SELECT PRODUCT
READY FOR USE
! To disable the rinse cycle, see the paragraph on
programming the machine.
Rinse and fill the
tank with fresh drinking
water, always up to the
max level.
Close the lid and
replace the tank in
position.
! Attention you will be
notified on the display
to fill the water tank.
This will happen already
with water.
The main switch is in
the "O" position. To
switch on, press the key
in the "I" position.
Close the front panel
by pressing firmly in the
centre. The machine
NA
7