Technical Data; Brief Description - Felisatti AP110/1400SE Instrucciones De Servicio

Brush machine
Voltage
Frequency
Input power
No-load speed
Max. disc diameter
Weight according EPTA-Procedure 01/2003
Read the operating instructions
Protection category II power tool; double
insulated
In accordance with essential applicable safety
standards of European directives
Wear eye protection
Wear a dust mask!
Wear ear protection!
Follow very carefully the instructions in this manual,
save it and keep it close at hand, ready to carry out any
inspection of parts that may be necessary.
If the tool is used with care and normal maintenance
is carried out, it will work well for a long time.
The manufacturing date – month and year - is
specified on the rating plate.
The functions and use of the tool you have bought
shall be only those described in this manual. Any other
use of the tool is strictly forbidden.
ILLUSTRATIONS
DESCRIPTION (See figures)
A Start-up switch
B Speed control
C Extractor connector
D Support roller
E Brush
F Cover of dust guard
G Depth adjustment wheel
H Dust guard
I Auxiliary handle
J Spindle blocking button
K Adjustment key
L Fixing screw for the brush
M Washer seating
N Spindle
O Hold-down lever
P Nut

TECHNICAL DATA

V~
Hz
W
min
-1
mm
kg
- 1 Allen wrench to change accessory
- 1 auxiliary handle
- Operating instructions
- Safety rules
- Warranty
This tool has been designed for polishing, sanding,
satin finishing (or artificial ageing) of wood and metal.
Required ambient conditions: -10 ° C to +40 ° C, relative
humidity of 80%, away from precipitations and excessive
dust. This manual provides information and requirements
that are necessary and sufficient for reliable, efficient and
safe operation of the tool. Always seeking to improve the
tool performance, the manufacturer reserves the right to
make minor design changes that may not be reflected in
this manual and do not decrease the efficiency and safety
of operation. This power tool is intended solely for dry
machining.
WARNING! Always unplug the machine before carrying
out work on it.
1.FITTING SAFETY DEVICES
1.1. Fitting the dust guard (Fig.2).
Insert the dust guard H in the plate collar of the machine
and turn it to the work position required. Fix it in this position
using the hold-down lever "O" . If the latter does not hold
the guard securely, then adjust the position of the screw P.
1.2. Fitting the auxiliary handle I (Fig.3)
ATTENTION! Always use the auxiliary handle in order to
avoid losing control of the tool and getting injured.
ATTENTION! Before starting the work, always check, that
the auxiliary handle is reliably fixed.
To screw the auxiliary handle "I" in its place on the dust
guard H on the left or on the right side.
2. FITTING AND REPLACEMENT OF BRUSH
To change the brush, proceed in the following manner
(Fig.3):
1. Unscrew the cover of the dust guard F.
2. Block the spindle, by pressing the blocking button
J.
3. With the hex wrench, unscrew the screw L, remove
the washer M and remove the brush E.
4. Place the new brush on the spindle.
ATTENTION! The adjustment keys K must always be
installed on the spindle.
AP110/1400SE
230~
50-60
1400
1000-4000
110
3.5
EQUIPMENT

BRIEF DESCRIPTION

BEFORE USING THIS TOOL
7