Stealth UHET 0.8 GPF Instrucciones De Instalación página 5

4.
5.
6.
7.
8.
TOILET SEAT INSTALLATION INSTRUCTIONS
(Seat included in Stealth All in One and Stealth System models)
1. Place the seat on the toilet, aligning the holes of the seat with
the holes in the back of the toilet bowl.
2. Insert the screw through the holes to secure it with the nut from
the bottom of the toilet, with the nut's tapered end on top.
3. Secure nut from the bottom of the toilet, use a regular screw-
driver to tight the fit. (See picture)
CAUTION: DO NOT OVERTIGHTEN THE SCREW AS IT MAY CAUSE
DAMAGE ON SEAT.
4. Push the decorative cap down.
Make sure that the toilet bowl is level. If the toilet tilts or is
rocking, insert shims under the base.
Install the plastic washer (be sure that the side marked "top"
is facing up), round metal washer, and full hex nut. DO NOT
OVERTIGHTEN. Cut off any excess bolt length and snap the
bolt cap in place, run a bead of caulk around the base of the
toilet for a finished look and to meet plumbing codes.
Install the toilet tank. ( The tank has been factory assembled
and has the gasket seal between the bowl and the bottom of
the tank and is ready to set in place.) Place the tank in place
with the two (2) metal washers and (2) nuts provided. DO NOT
OVERTIGHTEN.
Connect the water supply to the toilet fill valve and hand
tighten. Carefully connect the water supply to the shut-off
valve.
Open the shut-off valve slowly and checks leaks. Fill to the
water line. Adjust the level, if necessary by turning the black
screw on the top of the float.