Removing The Transport Support; Rear Spacers; Levelling; Door Reversibility - Electrolux A75298-SK1 Manual De Instrucciones

14
Installation
The appliance must be earthed. The power supply cable plug is provided with a contact for
this purpose. If the domestic power supply socket is not earthed, connect the appliance to
a separate earth in compliance with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Directives.

Removing the transport support

Your appliance is equipped with transport support to secure the door during transportation.
To remove them do these steps:
1. Open the door.
2. Remove the transport support from the
door sides.
3. Remove the transport support from the
lower hinge (some models).
Some models are fitted with a silencing pad
under the cabinet. Do not remove this pad.

Rear spacers

Install the spacers provided within the accessory bag as shown in the figure.
Install the spacers on the back side of the panel.

Levelling

When placing the appliance ensure that it stands
level. If necessary adjust the feet using the ad-
justment spanner supplied.
Door alignment is dependent on proper levelling.

Door reversibility

The door reversibility is not possible.
3
2