Place The Boundary Flags; Fit The Receiver Collar - Guardian Fence Guía De Uso

To Cross Hard Surfaces (driveways, sidewalks, etc.)
• Concrete Driveway or Sidewalk
(7C): Place the Boundary Wire
in a convenient expansion joint
or create a groove using a circular
saw and masonry blade. Place
the Boundary Wire in the groove
and cover with an appropriate
waterproofi ng compound. For best
results, brush away dirt or other
debris before patching.
• Gravel or Dirt Driveway (7D):
Place the Boundary Wire in a PVC
pipe or water hose to protect the
Boundary Wire before burying.

Place the Boundary Flags

Step
8
The Boundary Flags are visual reminders for your pet of where the Warning Zone is located.
1. Place the Test Light contact on the
contact points and hold the Receiver
Collar at your pet's neck height.
2. Walk towards the Warning Zone until
the Receiver Collar beeps (8A).
3. Place a Boundary Flag in the
ground (8B).
4. Walk back into the Pet Area until the
beeping stops.
5. Repeat this process around the
Warning Zone until it is marked with
Boundary Flags every 10 feet.
Note: If you cannot hear the beep, see the Test Light Instructions in Step 6.

Fit the Receiver Collar

Step
9
Important: The proper fi t and placement of your Receiver Collar is important for
effective training. The Contact Points must have direct contact with your pet's skin on
the underside of his neck.
To assure a proper fi t, please follow these steps:
1. Remove and discard the Guardian security tag from the collar
(9A or 9B).
2. Make sure that the battery is not installed in the Receiver Collar.
3. Start with your pet standing comfortably (
4. Place the Receiver Collar on your pet so that the "Guardian by
PetSafe" logo is facing your pet's chin. Center the Contact Points
underneath your pet's neck, touching the skin. Note: It is sometimes
necessary to trim the hair around the Contact Points to make sure that
contact is consistent.
5. Check the tightness of the Receiver Collar by inserting one fi nger
between the end of a Contact Point and your pet's neck. The fi t
should be snug but not constricting (9D).
6. Allow your pet to wear the collar for several minutes then recheck
the fi t. Check the fi t again as your pet becomes more comfortable
with the Receiver Collar.
7. Once you are satisfi ed with the fi t of the Receiver Collar then you
may trim any excess collar strap as follows (9E):
12
7C
8A
9C).
Customer Care Center 1-800-732-2677
7D
8B
Boundary
Wire
9A
9B
9C