Sunforce 11240 Manual Del Usario página 9

The remote control is included with your inverter and located on a keychain. To use the remote
control the receiver must first be plugged in to the inverter. The receiver box is attached to a cord
that can be plugged into a jack on the face of the inverter near the AC Outlets.
In the event the remote control is lost, disconnect the Remote Control Receiver from the inverter
by unplugging the cord from the jack.
The remote control is operational within 30 feet (9 meters) in open space.
The full-loaded Output Terminal is sharing the total output wattage capacity with the other
AC Outlets.
Therefore, the full-loaded output will be less than rated maximum output wattage when the
other AC Outlets are working.
LCD Display.
FAULT status – Future Protection.
1. Short Circuit Protection. The Inverter will automatically shut down until the short is removed.
2. Low Voltage Alarm. An alarm will sound when the voltage from the battery discharges, to
10.5+/-0.5 volts DC. This is an indication that the battery needs to be recharged.
3. Over Voltage Protection. The LED will illuminate RED and the Inverter will automatically turn
itself off, when the input exceeds16.5 +/-1 volt DC
4. Under Voltage Protection. The LED will illuminate RED and the Inverter will automatically turn
itself off, when the input is less than 10.0 +- 0.5 volts DC.
5. Overload Protection. The LED will illuminate RED and the Inverter will automatically turn itself
off, when the continuous draw of the equipment being operated exceeds rated capacity. Or the
surge draw of the equipment exceeds rated capacity watts.
6. Thermal Protection. The LED will illuminate RED and the Inverter will automatically turn itself
off when the circuit temperature exceeds 150°F. (65°C)
VDC
Press "SET" key to light up the Green LED beneath VDC.
The Input Voltage Level from the battery will be shown on the panel.
Example: 12.5V Input.
KW
Press "SET" key to light up the Green LED beneath KW.
The Power Consumption Load will be shown on the panel.
Example 1: 2500W Output
Example 2: 1380W Output
VAC
Press "SET" key to light up the Green LED beneath VAC.
The Output AC Voltage Level will be shown on the panel.
Example: AC 120V Output