Dip Switches; Hardware Installation - D-Link DSS-100E-18P Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

DIP Switches

5
1
5
6
2
6
7
3
7
8
4
8
5
1
5
6
2
6
7
3
7
8
4
8
The DIP switches on the front panel allow easy
configuration of the advanced features of the DSS-
100E-18P
DIP
Function Controlled
Switch
Switch all ports can communicate with each
other port and work as a common Unmanaged
Standard
Switch. *1 to 16 port supports Power over Ethernet
and transmit data at 10/100 Mbps.** 1 to 8 port
supports port priority to optimize port cache.
1 to 16 port can't communicate with
Isolate
each other, but each of them can
communicate with port 17 and 18.
The data rate of 9 to 16 port is limited to 10Mbps,
Extend
whereas the maximum transmission distance
of the port is increased to 250 meters.
Table 4

Hardware Installation

Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures, and personal injury:
Install the DSS-100E-18P in a cool and dry
place. Refer to the technical specifications in
the user manual for the acceptable operating
temperature and humidity ranges.
Install the switch in a site free from strong
electromagnetic sources, vibration, dust, and
direct sunlight.
Leave at least 10 cm of space to the left and right-
hand side of the switch for ventilation.
Visually inspect the power connector and make
sure that it is fully secured to the power cord.
Do not stack any devices on top of the switch.
2
Using the Switch on a Flat Surface
The included rubber pads can be placed on the
9
10
11
bottom of the device to prevent it from damaging
the surface it is placed on.
1. Remove the rubber pads from the adhesive strip.
2. Stick one pad on each corner on the bottom
panel of the switch.
Default
On
Mounting the Switch in a Rack
Off
The DSS-100E-18P can be mounted into a standard
19" server rack.
Off
1. Attach the included mounting brackets to the
sides of the switch and secure them using the
provided screws.
2. Install the switch into the rack.
3. Use the screws that were provided with the rack
to secure the switch to the rack.
12
13
14
15
16
17
18
9
10
11
Figure 4
Figure 5
Figure 6
/
1000
Link
Act
12
13
14
15
16

Publicidad

Tabla de contenido
loading

Tabla de contenido