LED Indicators
The LED indicators allow you to monitor, diagnose,
and troubleshoot potential problems with the switch,
connection, or attached devices.
LED
Color
State
Light on
Power
Green
Light off
On
Green
Blinking
Link/Act/
Speed
On
Amber
Blinking
Cable Diagnostics (During Boot Only)
Port Link/Act/
Speed LED Color
No Faults Detected /Good Cable
Green
Amber
Indication
Power on
Power off
Connection (or link)
at 1000 Mbps
Reception or
Transmission at 1000
Mbps
Connection (or link)
at 10/100 Mbps
Reception or
Transmission at
10/100 Mbps
Status
Connection
Open or Short Circuit
DIP Switches
The DIP switches on the front panel allow easy
configuration of the advanced features of the DGS-
1016D and DGS-1024D.
DIP
Function Controlled
Switch
Enables/Disable IEEE 802.az
EEE
Energy-Efficient Ethernet Feature
Flow
Enables/Disable Flow Control
Control
Feature
Port Isolation: See Below
Port
Storm Control: When enabled, a
Isolation
broadcast storm control threshold
and
value of 128 kbps will be applied
Storm
to incoming broadcast packets on
Control
all ports.
Port Isolation:
DGS-1016D - When enabled, ports 1 to 15 will
be isolated from each other, but will still be able to
communicate with port 16. Port 16 will be able to
communicate with all the ports available on this switch.
DGS-1024D - When enabled, ports 1 to 23 will
be isolated from each other, but will still be able to
communicate with port 24. Port 24 will be able to
communicate with all the ports available on this switch.
Note: The switch must be power cycled
after changing DIP Switch settings for new
settings to take effect
Additional Information
Additional help and product information is available
online at http://www.dlink.com.
Warranty Information
Please visit http://warranty.dlink.com/ for warranty
information for your region.
©2020 D-Link Corporation. All rights reserved.
Trademarks or registered trademarks are the property
of their respective holders. Software and specifications
subject to change without notice.
Default
On
On
Off
.
3 3