GE JVW5301 Instrucciones De Instalación página 4

TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencil and tape measure
Spirit level
Electric drill, #2 Phillips,
flat head, and 9/32" drill bit
Aluminized
Duct tape
REMOVE THE PACKAGING
CAUTION:
against sharp edges.
• Remove the duct covers.
• Remove the hardware bag, literature package
and other boxed parts.
• Remove and properly discard the protective
plastic wrapping and other packaging materials.
4
Installation Preparation
Safety glasses
Wire cutter/stripper
UL listed wire nuts
Strain relief for
junction box
Wear gloves to protect
PLAN THE INSTALLATION
CAUTION:
To reduce risk of fire and to
properly exhaust air, be sure to duct the air
outside – Do not vent exhaust air into spaces
within walls or ceilings or into attics, crawl spaces,
or garages.
PARTS SUPPLIED FOR INSTALLATION
• 1 Hardware Package
• 1 Literature Package
PARTS NEEDED FOR INSTALLATION
• 1 Strain Relief
• Power Supply Cable
• 1 Wall or Roof Cap (for external venting only)
• All Metal Ductwork (for external venting only)
• Recirculation Duct (for recirculation install only)
WARNING:
PERSONAL INJURY HAZARD
Because of the weight and size of the range hood
canopy. It is recommended that 2 people are used
to install the range hood. Failure to properly lift
range hood could result in damage to the product
or personal injury.
NOTE: This range hood can be installed as either
ducted or recirculation. In a ducted application,
this range hood can be vented through the wall or
ceiling. When installed for recirculation, the range
hood vents out the sides of the duct cover.
NOTE: Before making any cuts or holes for
installation, determine which venting method will
be used and carefully calculate all measurements.
31-10983-3