Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Storing your Rescue
• Charge battery to full capacity immediately after use and every 3 to 6 months in storage
to keep the internal battery fully charged to prolong the overall battery life
• Avoid storing in direct sunlight, in extreme heat or cold, and wet or damp areas
• It is recommended to keep this unit indoors when outside temperature is below 32°F
(0°C)
• Always store battery clamps attached to the posts on the unit and accessories properly
within the Rescue® LiFePO4 power pack case
Charging your Rescue
IMPORTANT! Charge immediately after purchase, and after each use and every
3-6 months. Only use the charging cables provided with the unit.
• Keeping the internal battery fully charged will help to prolong the overall battery life
• AC charging cable and DC charging cable are included with unit
• AC charging cable: Connect the AC plug to the unit, then connect the charger to a
grounded AC electrical outlet. The charger is now activated
• DC charging cable: Connect the DC plug to the unit, then plug the 12 volt adapter into
the DC socket or the car. The charger is now activated
• Always disconnect and store charging accessories properly within the Rescue
LiFePO4 power pack case
Operating Instructions
Turning Rescue
LiFePO4 power pack ON/OFF
®
• Press the power button for 3 seconds to switch on the device
• Press the power button for 3 seconds to switch off the device
5
LiFePO4 Power Pack
®
LiFePO4 Power Pack
®
®
Operating Instructions Cont.
Using LED Light
• Activate power button on the Rescue
®
• The light works in the following sequence by pressing the switch:
•
Press light button once – flashing white light
•
Press light button twice – steady White light
•
Press light button third time – turns Off light
Using USB Ports
• The 2 USB ports provide up to 2.4A at 5V DC
• Activate power button on the Rescue
LiFePO4 power pack
®
• Plug your USB device into the connector port of the unit
Test – Vehicle Battery
• Make sure the vehicle ignition is turned Off, the engine is not running
• Connect clamps to Red POSITIVE (+) clamp to the POSITIVE (+) post of battery,
then connect the Black NEGATIVE (-) clamp to the NEGATIVE (-) post of battery
• Activate power button on the Rescue® LiFePO4 power pack
• Press the TEST button once to choose battery test function
vehicle battery voltage and its status (Low, Mid, or Full)
Test – Vehicle Alternator
• The vehicle's engine will need to be running for this test
• Connect the jumpstart Red POSITIVE (+) clamp to the POSITIVE (+) post of
battery, then connect the jumpstart Black NEGATIVE (-) clamp to the NEGATIVE
(-) post of battery
• Activate power button on the Rescue® LiFePO4 power pack
• Press the TEST Button twice to choose alternator test function
display vehicle alternator output voltage and its status (Low or Full)
LiFePO4 power pack
, LCD will display
, LCD will
6
Publicidad
Tabla de contenido
