Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Introduction
.
With your new Philips ladyshave Softselect you can
quickly, easily and comfortably remove unwanted hair
from dry or wet skin.
This Philips ladyshave Softselect is equipped with an
adjustable shaving foil with three different zones for
shaving the underarms, bikini line and legs.
◗ You can use the ladyshave either dry or wet. If you
shave while taking a bath or shower, we advise you
to use soap or shaving foam for the most
comfortable shave. After use you can simply rinse
the ladyshave in the shower or under the tap. Make
sure the battery compartment is properly closed
during wet use and when cleaning the appliance.
◗ This Ladyshave can only be operated on batteries.
General description
.
A
Shaving foil
B
Softselect slide
C
On/off switch
D
Battery compartment
E
Cleaning brush
F
Comb attachment
Important
.
Read these instructions for use carefully before using the
appliance and save them for future reference.
◗ This appliance complies with the internationally
approved IEC safety regulations and can be safely
used in the bath or shower (fig. 1).
◗ Do not use or clean the appliance with water that is
hotter than shower temperature.
◗ Use and store the appliance at a temperature
between 15cC and 35cC.
◗ Keep the appliance out of the reach of children.
◗ This appliance is only intended for shaving and
trimming human hair. Do not use it for any other
purpose.
Preparing for use
.
The ladyshave runs on two R6 AA 1.5 volt batteries. We
strongly advise you to use Philips LR6 PowerLife batteries.
They supply sufficient energy for approx. 40 minutes of
shaving.
1
Pull the battery compartment downwards with
some force to remove it (fig. 2).
2
Put the batteries in the battery compartment
(fig. 3).
Make sure your hands and the appliance are dry when
inserting the batteries.
◗ Make sure the + and - poles of the batteries are
pointing in the right direction
3
Reattach the battery compartment to the appliance.
To avoid damage due to battery leakage:
-
Remove the batteries if the appliance is not going to
be used for a month or more.
-
Do not leave empty batteries in the appliance.
Using the appliance
.
Shaving
1
Set the softselect slide on the shaving head to the
position that corresponds to the body part you
wish to shave (fig. 4).
◗ Use the golden zone of the shaving foil for shaving
the underarms (fig. 5).
◗ Use the gold-striped zone of the shaving foil for
shaving the bikini line (fig. 6).
◗ Use the silver zone of the shaving foil for shaving
the legs (fig. 7).
4203 000 32751
2
Switch the ladyshave on (fig. 8).
3
Place the trimmers and the shaving foil gently on the
skin and move the ladyshave slowly over the skin
against the direction of hair growth while pressing it
lightly (fig. 9).
Make sure that both trimmers and the shaving foil are
always completely in contact with the skin.
◗ The angle between the skin and the ladyshave
should be 70c to get the best results.
◗ Thanks to the Aloe Vera Glider, the appliance glides
over the skin more easily and thus guarantees a
smooth shave while reducing the risk of skin
irritation (fig. 10).
Trimming
1
To trim the bikini zone, place the comb attachment
on the shaving head with the recess of the
attachment on the front of the appliance (fig. 11).
2
To trim the underarms, place the comb attachment
on the shaving head with the recess of the
attachment on the back of the appliance (fig. 12).
3
Switch the ladyshave on (fig. 8).
4
Move the appliance against the direction of hair
growth (fig. 13).
◗ Make sure the surface of the comb always stays in
contact with the skin.
Cleaning and maintenance
Do not use any corrosive detergents, scouring pads or
cloths, petrol, acetone etc. to clean the appliance.
After every use
Clean the ladyshave every time you have used it.
1
Switch the appliance off.
2
Remove the shaving head (fig. 14).
Do not exert any pressure on the shaving foil to avoid
damage.
3
Brush the hairs off the cutter block and the shaving
head. Make sure you also brush away any hairs that
have collected under the trimmers (fig. 15).
4
For extra thorough cleaning, you can also rinse the
appliance under the tap (fig. 16).
5
Always put the comb attachment on the shaving
head to avoid damage to the foil.
Twice a year
◗ Lubricate the shaving foil and the trimmers with a
drop of sewing machine oil twice a year (fig. 17).
Replacement
.
If you use the ladyshave two or more times a week, we
advise you to replace the shaving foil and cutter block
every two years.
-
The shaving foil may only be replaced with an original
Philips shaving foil (type HP6120).
-
The cutter block may only be replaced with an
original Philips cutter block (type HP2909).
-
If one or both trimmers are damaged or worn,
contact your Philips dealer or a Philips service centre
for replacement.
To replace the shaving head:
2
Remove the shaving head (fig. 14).
2
Press the sides of the shaving head slightly together
and remove the foil (fig. 18).
3
Make sure the softselect slide is in the middle
position (bikini line) when you insert the new foil
(fig. 19).
4
Press the sides of the shaving head slightly together
and insert the new foil (fig. 20).
.
1/16
Publicidad
