General Instructions; Ec Declaration Of Conformity - degardo LUNOCS Flame Instrucciones De Uso Y Montaje

PAIRING THE REMOTE CONTROL WITH THE LAMP
An unlimited number of lamps can be controlled with one remote control. One remote control can be
assigned to a maximum of four zones. To start the pairing (coupling) process, disconnect the lamp
from the power supply and then reconnect it. For lamps that are not yet paired, the LEDs illuminate red
(RGB) or permanently (LED warm white). Otherwise, the previous setting for the lamp is in use. Within
three seconds, press the "POWER ON" button (F5/G3) for each allocated zone. When the LED flashes
repeatedly, this indicates that the lamp and remote control are paired. To disconnect this assigned
pairing, disconnect the lamp's power supply. Then reconnect the power and repeatedly press the
Zone On key that was assigned to the lamp. The lamp will blink to signal that the pairing is no longer
assigned.
WIFI CONTROLLER
The WiFi controller enables you to control the LUNOCS lamps using an iPhone, iPad or iPod Touch
(iOS 5.1 or later), as well as an Android (version 2.2 or later) smart phone or tablet. All functions can be
controlled using the free app. The WiFi controller can be ordered under article number 227779.
CHANGING THE BATTERIES IN THE REMOTE CONTROL
Open the battery compartment by pushing the compartment lid off towards the back. Replace the
batteries as shown in the battery compartment (use two Micro cells, type AAA). Slide the lid back on
from the back until it clicks into place.

GENERAL INSTRUCTIONS

These instructions contain all of the necessary details for correct usage and care of Degardo LUNOCS
products. Please note the instructions and directions in this product information. Please keep these
instructions for future reference.

EC Declaration of Conformity

We, Degardo GmbH, Dehmer Straße 66, 32549 Bad Oeynhausen, hereby declare that the design of our
products conform to the following standards:
• "Niederspannungsrichtlinie" (Low Voltage Directive) 2006/95/EC
• EMV directive (Electromagnetic Compatibility): 2004/108/EG
•
This declaration is invalidated in the event of incorrect use or product modifications which were not
agreed with the manufacturer.
Bad Oeynhausen, dated 04.05.2015
Helmut Dennig (CEO DEGARDO GmbH)
LUNOCS www.degardo.de 15