ELECTRICAL HOOKUP FROM THE HOUSE TO PUMP AND PRESSURE TANK
For - 3-Wire Pumps - Control Box Is Required.
WARNING: This equipment is intended for installation by a technically qualified electrician.
Failure to install it in compliance with national and local electrical codes may result in electrical shock
or fire hazard, unsatisfactory performance, and equipment failure.
WARNING: Always disconnect power source before working on or near the pump, its
connected load and wiring. If the power disconnect is out of sight, lock it in the open position and
tag to prevent unexpected application of power.
NOTE: 3-wire pumps require a control box (See chart on page 6).
1. Determine proper voltage from breaker box
(sold separately) to pressure switch. (Fig. 1)
2. Remove the cover from the control box
(sold separately) and mount it in an indoor
location protected from moisture. (Fig. 2)
22
Copyright © 2011 Star Water Systems. All rights reserved.
1
2
Terminal
L2
Terminal
L1
L2
L1
Green
Ground
Screw
IL1170
Terminal
R
Terminal
Y
Terminal
R
Y
B
B
Green
Ground
Screw