Re S Olv Iendo Ba Ja Ca Lida D De Imprimir; Res O L V Ie N Do Baj A C Al I Da D D E Im Pr Es I Ón - HP DAILY JET HP1000 Manual De Operación

Re s olv iendo Ba ja Ca lida d de Imprimir

Print Result Description
Print is horizontally Check if the main roller is not contacting the print surface.
stretched The main roller must be flush with the print surface. If it is not flush
with the surface, this printing condition may occur.
Vertical misalignment This printing condition may be caused by an uneven print surface.
or banding
Special printin equipment will be required to resolve this issue.
(Please see P.16 Basic Operations)
Print message printed This printing condition may result from the main roller moving too
several times fast during a print.
This printing condition can occur if the printing speed is too fast.
When the printing speed exceeds the guidances, the printer will
automatically stop printing.
Please maintain an appropriate printing speed to achieve good
print results.
(Please see P.16 Basic Operations)
Check whether the printer is tilted during printing.
Print messaged is
slanted to one side The printer needs to be held parallel to the print surface.
(Please see P.16 Basic Operations)
Print message printed
several times
Check whether the auxiliary roller is in contact with the print surface
Blurry or smeared
during printing.
prints
The auxiliary roller needs to be on the printing surface. Otherwise,
it may cause this print result.
Poor Printing quality
(Please see P.16 Basic Operations)
Incorrect print density
Check if the ink or battery level is low.
If required, please replace the ink cartridge, replace the
Interrupted print job rechargeable batteries, or recharge the batteries.
(Please seee P.8 Ink cartridge installation)
(Please see P.10 Turning on the Printer, P.11 AC power and P.40
Low Battery)
This printing condition can occur if the printing speed is too fast.
When the printing speed exceeds the guidances, the printer will
automatically stop printing.
Please maintain an appropriate printing speed to achieve good
print results.
(Please see P.16 Basic Operations)
Horizontal The printout has horizontal misalignment or banding.
misalignment or Please conduct a printhead printing test.
banding If the test results in the same printing issues, please clean the
printhead a few times.
Perform the printhead printing test again.
(Please see P.38 Basic Cleaning Guide and P.39 Printhead printing
test)
If cleaning doesn't resolve the print condition, the printhead surface
may be scratched, or have a blockage.
Please replace the ink cartridge.
(Please see P.8 Ink cartridge Installation)
43