Replacement Of Foil; Disposal Of Used Foil; Adjustment Of Bag Length - PAXXO Pacto Safe 4.0 Manual Del Usuario

6. Replacement of foil

A red STOP mark indicates when the foil is running out. The foil should then be
replaced immediately. It is important to use the right type of foil as otherwise
functionality cannot be guaranteed.
Use the original foil from PAXXO, item no. 10880. Other types of foil might inflame
and start burning.

Turn off the switch.

Open the lid. Place the foil cassette around the funnel and
take the foil from the outside.

Make sure that the feeding wheels are gripping the foil.

Turn on the switch and wait approx. 5 seconds.

Press the foot pedal and check that the foil is feeding
down on both sides and that it is being welded.

Close the lid.

Check the welding result against the pictures in Section 10.

The Pactosafe is now ready for operation.

7. Disposal of used foil

The packaged waste should be collected in a container for hazardous waste and
handled according to local instructions. The system is tested for safe disposal of
cytotoxic waste for 7 days. For more information see www.pactosafe.com.

8. Adjustment of bag length

If required, the bag length can be adjusted. Avoid unnecessarily long bags to conserve foil
usage. The adjustment range is from approx. 140 mm to 400 mm.
The length of the bag is preset using a knob on the right of the front panel.
The preset value is the length of the next bag after sealing.
The bag length can be increased by keeping the foot pedal depressed before welding.
Paxxo AB / Bjurögatan 35, SE-211 24 Malmö, Sweden / Tel: +4640186025/ Fax: +4640183736 / www.paxxo.com
14