Eaton LUMARK WPMLED Instrucciones De Instalación página 3

Wire Guard Installation
Content
4 Wire guard plates, 2 screws, 4 washers, 2 Rubber
washers.
1. Clip the wire guard plates on the wire guard at proper
position. (Figure 3 and Figure 4.)
2. Open the glass door, un-tighten the glass screws on
each side of fixture.(Be careful not to lose the nuts and
glass clips inside the fixture.)
3. Install the wire guard according to (Figure 3.).
Installation Instructions - WPMLED
Metal Washer
Figure 3. and 4.
EATON
IB514013EN
Rubber Washer
Installation instructions
3