Controls & Features - Cub Cadet CSV 050 Manual Del Operador

Controls and Features
Recoil Starter
Hose Handle
WARNING:
can result in foreign objects being thrown into the
eyes, which can damage your eyes severely. Always
wear the safety glasses provided with this unit or
eye shields while operating or while performing any
adjustments or repairs.
Chipper Chute
Allows twigs and small branches up to 1-1/2" in diameter to be
fed into the impeller for chipping. See Fig. 4-1.
Nozzle Height Adjustment Lever
Used to adjust the nozzle ground clearance ranging
approximately 5/8" to 4 1/8".
Nozzle
Yard waste such as leaves or pine needles can be vacuumed up
through the nozzle for shredding.
Hose Assembly
Used as an alternative to the nozzle to vacuum yard waste such
as leaves or pine needles in hard to reach places. See Fig. 4-1.
10
Chipper Chute
Nozzle Height
Adjustment Lever
The operation of any chipper shredder
Bag
Figure 4-1
Nozzle/ Hose Vac Lever
The nozzle/hose vac handle is located on top of the nozzle. Use
it to switch vacuum suction between the nozzle and the hose
assembly.
Hose Handle
Used to guide hose assembly when vacuuming.
Engine Switch
The engine switch is located on the engine. Turn it on when
starting the engine and use it to turn off the engine.
Choke
The choke is located on the engine and when activated, closes
the choke plate on the carburetor and aids in starting the engine.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand
behind unit and pull the recoil starter to start engine.
4
Hose Assembly
Nozzle/Hose
Vac Lever
Nozzle