Maintenance & Adjustments
Maintenance
General Recommendations
•
Always observe safety rules when performing any
maintenance.
•
The warranty on this chipper/shredder vacuum does not
cover items that have been subjected to operator abuse or
negligence. To receive full value from warranty, operator
must maintain the equipment as instructed here.
•
Changing of engine-governed speed will void engine
warranty.
•
All adjustments should be checked at least once each
season.
•
Periodically check all fasteners and make sure these are
tight.
WARNING:
Always stop engine, disconnect spark
plug, and ground against engine before performing
any type of maintenance on your machine.
Lubrication
1.
Lubricate each wheel shoulder screw (rear wheel) and pivot
arm axle (front wheel) once a season with light oil.
2.
Lubricate the pivot points of the nozzle height adjustment
levers once a season with light oil.
3.
Lubricate the locking rod with light oil to ease the
application of attaching on or removing bag.
4.
Lubricate the nozzle/hose vac lever on top of the nozzle
once a season with light oil. See Fig. 6-1.
Figure 6-1
5.
Follow the separate engine manual packed with your unit for
lubrication instructions.
Equipment Care
•
Clean the chipper/shredder vacuum thoroughly after each
use.
•
Wash bag periodically with water. Allow to dry thoroughly
in shade.
•
If the flail screen becomes clogged, remove and clean as
instructed below.
NOTE: Cleaning with a forceful spray of water is not
recommended as it could contaminate the fuel system.
Engine Care
NOTE: Refer to the engine operation and maintenance sections
in this manual for detailed instructions.
•
Maintain oil level.
•
Service air cleaner every 100 hours or once a season under
normal conditions. Clean more frequently under extremely
dusty conditions.
•
Clean spark plug and reset the gap every 25 hours or once
a season.
•
Clean engine regularly with a cloth or brush. Keep the area
around the top of the engine clean to permit proper air
circulation. Remove all grass, dirt, and combustible debris
from muffler area.
6
13