Daily Use And Operation; Automatic Mode - Soehnle AIRFRESH CLEAN 400 Instrucciones De Manejo

GB
Then insert the unpacked filter again, close
the device again and turn it over again.
5. Wait until the device has reached room
temperature (approx. 2 hours).
6. Connect the power cord to a wall outlet.

7. Daily use and operation

PM 2,5 sensor and LED ring
The current air quality is continuously determined
by Airfresh Clean 400 in the form of the PM 2.5
value. The PM 2.5 value is defined as dust at
which 50 % of the particles are < 2.5μ and rep­
resents the fine dust load per m³.
The illuminated LED ring on the upper side
indicates the current level of fine dust pollution
caused by different colours:
RED = high load (>50 µg/m³)
PINK = medium load (20 ­ 50 µg/m³)
LILA = low load (10 ­ 20 µg/m³)
BLUE = no load (0 ­ 10 µg/m³)
Please remove the protective flap in front of the PM2.5 sensor
(C) only in an emergency. Please do not allow any objects or
other foreign bodies to come into contact with the sensor.
Switching on and off
Press the ON/OFF button (L) to turn the
Airfresh Clean 400 on or off. The ON/OFF
control lamp lights up.
First press:
Device is switched on
Press twice:
Activates the automatic mode
Press the third time:
Deactivates the automatic mode.
Press four times:
Device is switched off
The control lamps light up accordingly.
12

Automatic mode

By pressing the (L) button as described
above, the Airfresh Clean 400 is also set to
automatic mode. In this mode, the unit
automatically adjusts the fan speed in
relation to the air quality in the room. This
ensures you always get the best possible
air quality. The control lamp for AUTO
lights up.
Setting the operating time
Press button (I) to set the desired oper­
ating time. Choose between 2, 4 and 8
hours. The control lamp lights up ac­
cordingly. The device switches off auto­
matically after the time has elapsed. If
no operating time has been selected
(no indicator light is lit), the Airfresh
Clean 400 runs in continuous operation.
Changing the fan speed
Press button (K) to select the fan speed
and thus the desired intensity of air
discharge:
Low (I) - Medium (II) - High (III) -
Turbo (all indicator lights on)
UV-C lamp and night mode
Press button (J) once to switch on the
UV­C lamp inside the Airfresh Clean 400
(UV­C control lamp lights up). Press again
to activate the night mode without
switching off the UV­C lamp (UV­C con­
trol lamp lights up, NIGHT control lamp
flashes). By further pressing button (J)
you can switch off the UV­C lamp (UV­C
control lamp is off, NIGHT control lamp
flashes) or switch both off (UV­C control
lamp is off, NIGHT control lamp is off ).
Night mode
In night mode, you can run the Airfresh
Clean 400 without being disturbed by