14
14
Slot
1.
J
20G
These tabs must insert into the slots.
Post
2.
J
20G
Flip the drawer over onto the LEFT DRAWER SIDE (D32).
Diagram 1. Insert the tabs on a DRAWER STOP (20G) into the slots in a EXTENSION SLIDE (J). You may need to insert one tab
first, then the other.
Diagram 2. Visually check that the DRAWER STOP (20G) is seated in the EXTENSION SLIDE (J).
Diagram 3. If the DRAWER STOP is not seated, use your hammer to gently tap the SLIDE until the tabs are properly seated in
the slots.
Now, fasten this EXTENSION SLIDE (J) to the RIGHT DRAWER SIDE (D127). Use two GOLD 5/16" FLAT HEAD SCREWS (3S)
through holes #1 and #3.
Repeat steps 13 and 14 for the other drawers.
Page 18
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
20G
J
Seated
www.sauder.com/services
3S
1
J
2
3
D127
D32
3.
Open end
415978