Panasonic EY46A5 Manual De Instrucciones página 12

Low battery warning lamp
EN
DE
FR
Off
IT
(normal
operation)
NL
Excessive (complete) discharging of
ES
lithium ion batteries shortens their service
life dramatically. The tool includes a
DA
battery protection feature designed to
prevent excessive discharging of the
SV
battery pack.
• The battery protection feature activates
NO
immediately before the battery loses its
charge, causing the low battery warning
FI
lamp to fl ash.
• If you notice the low battery warning
TR
lamp fl ashing, charge the battery pack
immediately.
PL
• If it is started with too little battery power
remaining, the tool may stop operating
CS
without the low battery warning lamp
fl ashing fi rst. This indicates that there is
HU
too little battery power remaining to use
the tool, and the battery pack should be
charged before further use.
• If the tool is subject to a sudden load
during use that causes the motor to lock
up, the overdischarge prevention sensor
may be triggered, and the low battery
warning lamp may fl ash. The lamp will
stop fl ashing once you address the
cause of the motor's locking up and cycle
the trigger.
Flashing
(No charge)
Battery protection
feature active
- 12 -
[Battery Pack]
For Appropriate Use of Battery
Pack [Fig.10]
• The rechargeable batteries have a
limited life.
• Do not use the battery pack soaked in
conductors like water.
• For optimum battery life, store the Li-ion
battery pack following use without
charging it.
• When operating the battery pack, make
sure the work place is well ventilated.
For safe use
• The battery pack is designed to be
installed by proceeding two steps for
safety. Make sure the battery pack is
installed properly to the main unit before
use.
• If the battery pack is not connected fi rmly
when the switch is switched on, the
overheat warning lamp and the battery
low warning lamp will fl ash to indicate
that safe operation is not possible, and
the main unit will not rotate normally.
Connect the battery pack into the unit of
the tool until the red or yellow label
disappears.
• Only use rechargeable battery packs for
Panasonic rechargeable tools. Do not
use modifi ed battery packs (including
battery packs which have been
disassembled and parts replaced).
• Do not use deteriorated battery packs.
There is a risk of the generation of heat,
ignition and explosion.
• If a battery pack leaks fl uid, cease use,
keep away from open fl ames, and return
it to the store immediately.
• Attach the battery pack by sliding until
the yellow and red labels are no longer
visible, and check that it does not fall out
of place.
- Failure to do so may result in scalding.