Operating; Connecting To The Asc - Waeco ASC G Instrucciones De Uso

Operating

5.3.2 Setting Wi-Fi kit to Access Point Mode via web browser
1. Be sure you are connected to the ASC.
2. Open the user interface.
3. Go to Unit info and select Wi-Fi Setup.
4. Select the Access point mode: Wi-Fi kit creates its own network
option.
5. Insert credentials (new SSID and new password) to be used when
connecting to ASC and remember SSID and password.
6. Click on the Confirm button.
✔ The ASC is rebooting.
✔ The previous Wi-Fi network connection is being disabled and the new
Wi-Fi network is being established.
✔ You can now connect your device to the ASC (see chapter "Connect-
ing to the ASC" on page 8).
6 Operating
If the ASC G Wi-Fi kit is connected to the ASC's USB port, the ASC's dis-
play shows a Wi-Fi symbol.
6.1

Connecting to the ASC

If you have already set up a connection to the ASC G Wi-Fi kit once on
your device, the access data is usually stored in your device. Otherwise:
1. In the basic menu of the ASC, go to Other selections > Wi-Fi kit >
Show info.
✔ The ASC displays the mode, the credentials and the IP address of the
user interface.
2. If you connected to ASC for the first time in Client Mode check the
displayed IP address.
3. If Access Mode is displayed, proceed according to chapter "Con-
necting to ASC in Access Point Mode" on page 8.
If Client Mode is displayed, proceed according to chapter "Connect-
ing to ASC in Client Mode" on page 9
6.1.1 Connecting to ASC in Access Point Mode
1. If you use a device with an active SIM card (e. g. cell phone) enable
the "airplane mode" on your device.
2. Be sure Wi-Fi is enabled on your device.
3. Connect your device to the ASC's Wi-Fi network.
8
ASC G Wi-Fi kit
EN