Publicidad
Idiomas disponibles
Idiomas disponibles
3. Assembly of accessories
Before assembly always remove the plug
from the mains.
Warning! Change accessories by
inserting an accessory into the collet (or
chuck) as far possible to minimize run out
and unbalance.
Assembly of accessories
Fig. 1
Press down the axle locking button (2) and hold
it down. Using the chuck spanner you can undo
the chuck (1). Put the accessory in its place. Hold
down the axle locking button when you fasten the
spring chuck with the spring chuck spanner.
To mount an accessory in the flexible shaft, lock
the spindle by putting the pin in the hole.
Then loosen the chuck with the spanner and place
the accessory.
Keep the pin in place and tighten the chuck.
Make sure to remove the pin before operating the
machine.
Operation
Switch on the machine by engaging the on/off
switch (A) By adjusting the adjusting wheel (B)
you can regulate the speed of the Combitool. Do
not put the machine down when the motor is still
running. Do not place the machine on a dusty
surface. Dust particles may enter the mechanism.
Too high a load at a low speed of the
Combitool can burn out the engine.
4. Mounting the flexible shaft
and stand
Flexible shaft
Fig. 2
Screw the ring off the chuck and remove it.
Mount the flexible shaft on the Combitool, placing
the inner shaft (1) in the chuck. The ring of the
flexible shaft (2) can then be fastened onto the
Combitool.
Never operate the axle locking button if
the engine is still rotating.
Stand for the Combitool
•
Mount the stand on the side of a workbench or
worktop with a maximum thickness of 60 mm.
•
The height of the stand is adjustable. Loosen
the top tube of the stand by turning it
anticlockwise. Draw the tube out to its
maximum height and secure it by turning the
tube clockwise. The height of the suspension
bracket is adjustable by loosening the black
knob. After adjusting the suspension bracket
to the correct height, retighten the knob.
•
Attach the Combitool to the suspension
bracket of the stand; this suspension bracket
can be turned 360°.
Accessories for the Combitool
Always check that the maximum rpm of the
accessory is suitable for the maximum speed of
the Combitool.
Grinding stones
Fig. 3
When using a grinding stone the first time, use the
dressing stone to balance it. The dressing stone
can also be used for cleaning the surface or to
give the grinding stone a special shape.
Material
Speed setting
Stone, shell
-
Steel
+
Aluminium, brass
+ -
Plastic
-
Felt wheels
Fig. 4
The felt wheels should be screwed on the
mandrel.
Material
Speed setting
Steel
+
Aluminium, brass
+ -
Plastic
+
Sanding bands and disc
Fig. 5
Material
Speed setting
Wood
+ +
Steel
-
Aluminium, brass
+ -
Plastic
-
EN
7
Publicidad
