Your New Radio; Batteries; How To Install The Nimh Battery; How To Install Aa Batteries - Motorola XTN446 Manual De Instrucciones

YOUR NEW RADIO

Motorola XTN446 two-way radios operate on PMR446 frequencies,
and can be used in any country where PMR446 frequencies are
authorized, subject to applicable regulations.
Please refer to the diagrams and tables on the inside front cover of
this manual.

Batteries

Your radio is powered by a Nickel-Metal Hydride (NiMH)
rechargeable battery pack or by 4 AA batteries. Please refer to
page 13 for battery life information.

How To Install The NiMH Battery

1. Slide the ribbed latch on the bottom of the radio away from the
battery door and towards the contacts
2. Slide the door towards the bottom of the radio and lift off
3. Position the battery, with the Motorola logo side facing up and the
battery contacts towards the bottom of the radio, into the top of the
battery compartment.
B
4. Firmly press the battery up and into the battery compartment.
5. Slide and snap the battery door into place.

How To Install AA Batteries

Warning
This product is intended to be powered by the designated Motorola
rechargeable pack (NTN8971 or NNTN4190) or by primary AA
Alkaline cells ONLY. Other AA cells (such as NiMH or NiCd) are not
suitable, as product damage or personal injury could occur in the
unlikely event that a continuous short circuit is applied to the
charging contacts located on the bottom of the unit.
5 English
1. Remove the battery door
2. Insert the 4 AA batteries, ensuring that the correct polarity is
observed.
3. Slide and snap the battery door into place.

How To Charge The NiMH Battery Pack Using The Rapid Charger

(IXPN4000 or IXPN4001)
The NiMH battery pack can be charged whilst in the radio or on its
own. To get maximum use from the battery, charge overnight (16
hours) before you use it for the first time. Subsequent charges will
only require up to 3 hours of charging time.
1. Plug the power supply into the charger pocket
C
2. Plug the power supply into an AC outlet.
3. Place the radio (including the battery), or the NiMH battery pack
only, in the pocket
D
Note: The charge time will be extended, and the battery meter will be
inaccurate, if the radio is left on while charging.

Charger Indicator Lights

Red: Rapid charge mode (up to 2 hours)
Flashing Green: Trickle charge mode after rapid charge (1 hour)
Green: Charging complete
Flashing Red: The charger is waiting for the battery
voltage/temperature to be within the permitted
rapid charge range
No Indication Radio or battery not properly inserted in the
charger pocket
Note: If you notice the LED flashing red for more than a minute, the
battery is faulty and should be replaced.