Safety Precautions - OTC 9106B Lista De Partes E Instrucciones De Funcionamiento

Parts List & Operating Instructions
WARNINGS: To prevent personal injury,
•
Read and understand all safety precautions and operating instructions before using
this pump. If the operator cannot read these instructions, operating instructions and
safety precautions must be read and discussed in the operator's native language.
•
Only qualified operators should install, operate, adjust, maintain, clean, repair, or
transport this machinery.
•
Wear eye protection that meets ANSI Z87.1 and OSHA standards.
•
These components are designed for general use in normal environments. These
components are not specifically designed for lifting and moving people, agri-food
machinery, certain types of mobile machinery, or special work environments such as:
explosive, flammable, or corrosive. Only the user can decide the suitability of this
machinery in these conditions or extreme environments. SPX will supply information
as necessary to help make these decisions.
•
Avoid off-center loads that could damage the cylinder or ram and/or cause loss of
load, possibly resulting in serious injury or death. Control the load at all times to
prevent shearing the threads and loss of load. Ensure everyone is clear of the load.
•
Before operating the pump, tighten all hose connections. Do not overtighten.
Connections need only be tightened securely and leak-free. Overtightening can cause
premature thread failure or high pressure fittings to split at pressures lower than their
rated capacities.
•
Should a hydraulic hose rupture, burst, or become disconnected, immediately shut off the pump and
turn the release valve knob counterclockwise to release all pressure. Never grasp a leaking,
pressurized hose with your hands. The force of escaping fluid could cause serious injury.
•
Periodically inspect the hose for wear. Do not subject the hose to potential hazards such as fire,
sharp surfaces, extreme heat or cold, or heavy impact. Do not allow the hose to kink, twist, curl,
crush, cut, or bend so tightly that the fluid flow within the hose is blocked or reduced. These
conditions could damage the hose, which could result in personal injury.
•
To prevent deterioration, hoses must not come in contact with corrosive materials, such as creosote-
impregnated objects and some paints. Hose deterioration can result in personal injury. Consult the
manufacturer before painting a hose. Never paint a coupler.
•
Do not use the hose to move attached equipment. Stress can damage the hose and possibly cause
personal injury.
•
Hose material and coupler seals must be compatible with the hydraulic fluid used. Use only approved
hydraulic fluid.
•
All components in the hydraulic system must match the maximum pressure rating of the pump.
•
To prevent expelling high pressure oil into the atmosphere, do not extend the cylinder beyond the
suggested maximum stroke. If this does occur, seals must be replaced.
•
Do not exceed the rated capacity of the cylinder. Excess pressure can result in personal injury.
© 2007 SPX Corporation

Safety Precautions

Form No. 544306
Sheet No. 2 of 3
Issue Date: Rev. A, August 27, 2007