Important - Delta 17-950L Manual De Instrucciones

IMPORTANT: Make certain that the tapered hole in the
bottom of spindle (T) Fig. 13, and the taper on the spindle
adapter (U) are clean and free of grease, lacquer, or rust-
preventive coatings.
NOTE: Household oven cleaner can effectively remove
these coatings from the spindle and spindle adapter.
However, carefully follow the manufacturer's safety rules
regarding its use.
21. Push the spindle adapter (U) Fig. 13 into the spindle
(T). making certain that the tang (V) engages the
mating slot inside the spindle (T).
RISk OF PROPERTY dAMAgE . To
avoid damage to the laser, prevent contact of the
laser pod with a cleaning solution . You can clean the
laser pod with a dry cotton cloth .
IMPORTANT: Make certain the spindle taper (O) Fig. 14,
and tapered hole in chuck (P) are clean and free of any
grease, lacquer or rust preventive coatings.
NOTE: Household oven cleaner can effectively remove
any substance from the chuck. However, carefully follow
the manufacturer's safety rules concerning its use.
IMPORTANT: Open the chuck jaws as wide as possible,
making sure that the chuck jaws are inside the chuck.
22. Holding chuck on taper of spindle, tap with a soft tip
hammer (Q) or a block of wood and hammer to set
chuck, as shown in Fig. 15.
RISk OF PROPERTY dAMAgE . To
avoid damage to the chuck, NEVER drive the chuck on
the spindle with a metal hammer.
23. Thread the three pinion shaft handles (R) in the three
holes located in the pinion shaft hub (S) Fig. 16.
V
Fig . 13
Fig . 14
Fig . 15
S
13
T
U
O
P
Q
R
Fig . 16