Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEP 6
Install the Sprocket Cover
1. Position the sprocket cover over the sprocket as shown and
fasten to the mounting plate with 8x3/8" hex screws provided.
You have now finished assembling your garage door opener.
Please read the following warnings before proceeding to the
installation section.
HARDWARE SHOWN ACTUAL SIZE
Hex Screw #8x3/8"
INSTALLATION
To reduce the risk of SEVERE INJURY or DEATH:
1. READ AND FOLLOW ALL INSTALLATION WARNINGS AND
INSTRUCTIONS.
2. Install garage door opener ONLY on properly balanced and
lubricated garage door. An improperly balanced door may
NOT reverse when required and could result in SEVERE
INJURY or DEATH.
3. ALL repairs to cables, spring assemblies and other hardware
MUST be made by a trained door systems technician BEFORE
installing opener.
4. Disable ALL locks and remove ALL ropes connected to
garage door BEFORE installing opener to avoid
entanglement.
5. Install garage door opener 7 feet (2.13 m) or more above
floor.
6. Mount the emergency release within reach, but at least 6 feet
(1.83 m) above the floor and avoiding contact with vehicles
to avoid accidental release.
7. NEVER connect garage door opener to power source until
instructed to do so.
8. NEVER wear watches, rings or loose clothing while installing
or servicing opener. They could be caught in garage door or
opener mechanisms.
(Packed with the
sprocket cover)
IMPORTANT INSTALLATION INSTRUCTIONS
To avoid possible SERIOUS INJURY to finger from moving garage
door opener:
ALWAYS keep hand clear of sprocket while operating opener.
l
Securely attach sprocket cover BEFORE operating.
l
Sprocket
9. Install wall-mounted garage door control:
within sight of the garage door.
l
out of reach of children at minimum height of 5 feet
l
(1.5 m).
away from ALL moving parts of the door.
l
10. Place entrapment warning label on wall next to garage door
control.
11. Place manual release/safety reverse test label in plain view on
inside of garage door.
12. Upon completion of installation, test safety reversal system.
Door MUST reverse on contact with a 1-1/2" (3.8 cm) high
object (or a 2x4 laid flat) on the floor.
13. To avoid SERIOUS PERSONAL INJURY or DEATH from
electrocution, disconnect ALL electric power BEFORE
performing ANY service or maintenance.
14. DO NOT install on a one-piece door if using devices or
features providing unattended close. Unattended devices and
features are to be used ONLY with sectional doors.
11
Hex Screws
#8x3/8"
Cover
Sprocket
Mounting
Plate
Publicidad
Capítulos
Tabla de contenido
