One-Piece Doors - Craftsman 139.54920 Manual Del Propietário

Abre-puertas de garaje inteligente
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fasten the Door Bracket (Continued)

ONE-PIECE DOORS

Please read and comply with the warnings and reinforcement
instructions on the previous page. They apply to one-piece doors
also.
Center the door bracket on the top of the door, in line with the
l
header bracket as shown. Mark either the left and right, or the
top and bottom holes.
Metal Doors: Drill 3/16" pilot holes and fasten the bracket
l
with the 1/4"-14x5/8" self-threading screws provided.
Wood Doors: Drill 5/16" holes and use 5/16"x2" carriage bolts,
l
lock washers and nuts (not provided) or 5/16"x1-1/2" lag
screws (not provided) depending on your installation needs.
NOTE: The door bracket may be installed on the top edge of the
door if required for your installation. (Refer to the dotted line
optional placement drawing.)
Header Wall
2x4 Support
Header
Bracket
Door
Bracket
Optional
Placement
of Door
Bracket
Vertical
Centerline of
Garage Door
Finished Ceiling
HORIZONTAL AND VERTICAL
REINFORCEMENT IS NEEDED
FOR LIGHTWEIGHT GARAGE
DOORS (FIBERGLASS, ALUMINUM,
STEEL, DOORS WITH GLASS
PANEL, ETC.). (NOT PROVIDED)
For a door with no exposed framing,
or for the optional installation, use
lag screws 5/16"x1-1/2" (Not Provided)
to fasten door bracket.
19
HARDWARE SHOWN
ACTUAL SIZE
Self-Threading Screw
1/4"-14x5/8"
Self-Threading
Screw
1/4"-14x5/8"
Door
Bracket
Top of Door
(Inside Garage)
Top Edge
of Door
Optional
Placement
METAL DOOR
Lock
Nut
Washer
5/16"-18
5/16"
Top of Door
Door
(Inside Garage)
Bracket
Top Edge
of Door
Optional
Placement
Carriage Bolt
5/16"x2"
(Not Provided)
WOOD DOOR

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido