Button Control; Touch Control - Gorenje TH60E3X Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 42
OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood is switched on
for 5 minutes prior to cooking and left in operation during cooking and for approximately another 15 minutes after terminating
cooking. Below described three types of operation.
ROCKER SWITCH
The hood operation is controlled by (three) switches, which are located on each side. They are visible when the telescopic
front is ejected.
The telescopic hood is equipped with a limit switch. Every time you eject the telescopic front, the hood will start operating on
the previously set gear.
1
3
2
The button labeled as
Pressing the
will not trigger the hood motor.
When the front panel is returned to the closed position, the limit switch turns off the hood motor and also turns off the light.
If the hood motor and light switch are already in ON state, the hood motor will start operating and the lights will turn on, when
the front panel is pulled out.

BUTTON CONTROL

TOUCH CONTROL

10
1.
0 – Turn off the hood.
I – hood operating on speed level 1.
↓– shift to enable motor speed II or motor speed III.
2.
II – hood operating on speed level 2 (when switch 1 in position ↓) .
III – hood operating on speed level 3 (when switch 1 in position ↓).
3.
O /
– Light ON / OFF.
is used to turn the light ON or OFF. The lighting in the hood works independently of the hood engine.
– Hood operation ON / OFF. When pressing the button, the hood will start to operate on
speed level 1.
– Press the Speed 2 button to start the motor with speed 2.
– Press the Speed 3 button to start the motor with speed 3.
– Light button to switch the light ON. Press again to switch the light OFF.
– Press the On/Off button to start selecting the motor speeds.
– Press the Speed 1 button to start the motor with speed 1.
– Press the Speed 2 button to start the motor with speed 2.
– Press the Speed 3 button to start the motor with speed 3.
– Press the Light button to switch the light ON. Press again to switch the light OFF.

Publicidad

Tabla de contenido
loading

Tabla de contenido