Grinder Assembly - Weston 36-0801-W Manual De Instrucciones

GRINDER ASSEMBLY

1. A. If you are using a clamp down #8 or #10 Grinder, slide the Protector Pad
onto the foot of the Grinder and tighten the Clamp Screw to secure the Grinder
to the work surface. Allow ample room for the Handle to rotate.
B. If you are using a bolt down #22 or #32 Grinder, the body of the Grinder
can be attached to a solid work surface using appropriately sized screws (not
provided). Allow ample room for the Handle to rotate.
FIGURE 1
2. Slip the plastic Auger Bearing
Auger
flange-end, face-first, over the
Bearing
Auger driver end. FIGURE 1
Auger
3. Together, carefully insert the
Knife
Auger Bearing & Auger inside
the Grinder Body. Position
Grinder
and extend the Auger Bearing
Body
& Auger into and through the
Auger
Notch
Pin
center of the far hole. FIGURE 1
Plate
Front
4. Secure the square Auger
Ring
Pin to the Auger. Handling
Nut
with care, turn the Knife so the
sharp blades face out. Then
slide it square-end-first, over the
FIGURE 2
square portion of the Auger Pin.
Handle
FIGURE 1
5. Slide the Plate of choice over
Thumbscrew
the round portion of the Auger
Pin. Align the notch on the Plate
with the notch in the Grinder
Body so that the Plate fully sits in
the opening of the Grinder Body.
6. Snugly screw on the Front Ring Nut. DO
NOT OVER TIGHTEN! If the Front Ring
Nut is screwed onto the Grinder Body too
tightly, the Auger will be hard to turn/will
not turn.
7. Slide the Handle over the exposed end
of the Auger and lock it in place with the
Thumbscrew. FIGURE 2
7