Assembly - Shindaiwa HT2510 Manual Del Propietario - Operador

Assembly HT2510
(1) Attaching the Rear Handle
to the Gearcase
1. Temporarily remove the 5 mm x 12 mm
index bolt.
2. Loosen, but do not remove, the 5 mm x
25 mm clamp screw.
3. Position the rear handle assembly as
shown. Starting from the rear of the
trimmer, push the throttle cable, igni-
tion wire, and ground wire through the
handle mounting bracket.
4. Slide the rear handle into the handle
mounting bracket until it bottoms. Use
care to avoid pinching or otherwise
damaging the wires and cable.
Align the hole in the rear handle
 
with the matching hole in the handle
mounting bracket, and then install
and firmly tighten the 5 mm x 12 mm
index bolt.
Tighten the 5 mm x 25 mm clamp
 
screw firmly.
Throttle Cable,
Ignition, and
Ground Wires
Rear Handle

Assembly

Clamp Screw
Index Bolt
Figure 4
WARNING!
Incorrect assembly could expose the operator to serious
injury! Read and follow assembly instructions carefully.
6
(2) Installing the Powerhead
on the Gearcase
 Orient the gearcase assembly to the
powerhead as shown, and secure
with the three 6 mm x 16 mm
screws.
1. Securely tighten screws A and B.
2. Push screw C through the eye ter-
minal in the throttle control ground
wire, and then install and firmly
tighten the screw to the powerhead.
Powerhead
Screws A
and B
Figure 5
(3) Install the Front Handle
 The front handle is installed over a
5 mm bolt on the guide bar.
1. Install the 5 mm flange nut over the bolt
on the guide bar, and then tighten the
nut firmly.
5 mm
Flange Nut
Figure 6
Screw C
Front
5 mm
Handle
Flange Nut
Bolt