Cooper Lighting REGENT MS185 Instrucciones página 4

MS185,MS185W I.S. 325-1417
How to operate your fixture
Step 1: Move slide switch on bottom of the sen-
sor to "TEST". Set sensitivity knob to
medium (halfway) (L).
Step 2: Turn on the power to fixture. Allow fix-
ture to warm up approximately 40 sec-
onds before testing. (Lights will come on
and stay on during warm-up
period.)
Step 3: Aim sensor head toward desired detection area, maintaining a 15° down
angle to allow moisture to drain. NOTE: Maintain air spacing between
lamps and sensor head, at least 1". Make sure sensor head is positioned
with control switches facing towards the ground.
Step 4: Walk across the detection zone at the farthest distance you wish your
detector to detect motion.
Step 5: Adjust sensitivity until you get desired results. Lights will turn off 4 sec-
onds after all motion stops.
Step 6: Move slide switch to 4 MIN or 12 MIN (AUTO mode). At dusk, lights will
operate in the AUTO setting.
How to select your desired feature
Mode of
operation:
Auto Setting
(motion activated)
Lights should turn on with
motion only at night and
should turn off after
4 or 12 minutes.
Dusk to Dawn Setting
(activated only at night)
Lights should stay on from
dusk to dawn and then reset
to the auto setting next
dawn.
Standard Floodlight
Setting
Lights should stay on
continuously both day and
night (must be reset
manually).
Test Setting
Lights should turn on with
motion both day and night.
Lights should turn off after
4 seconds.
Return to Auto Setting
(motion activated)
From any of the above
settings.
1/7/04 3:59 PM Page 4
Set slide switch
on sensor to:
4 MIN
or
12 MIN
4 MIN
or
12 MIN
TEST
TEST
4 MIN
or
12 MIN
4
THIS IS THE
BOTTOM SIDE
OF THE MOTION
DETECTOR
L
SENSITIVITY
TEST 4 MIN 12 MIN
How to set
power switch:
Keep the power to
the fixture on.
Turn power on and off twice
within 3 seconds.
Turn power on and off twice
within 3 seconds.
Keep the power to the
fixture on.
Turn the power "OFF" for at
least 40 seconds., then
back "ON".