OHAUS EX124 Manual Del Usuario página 4

EN-2
2.3 Terminal Setup
When the Explorer is delivered, the Terminal is already attached (docked) to the Base. No additional setup is necessary.
However the Terminal needs to be detached temporarily in order to assemble parts of the Draft Shield. Refer to the
illustrations and instructions below to identify and assemble your Explorer Balance.
Note: The Terminal is identical for all Explorer Balance models.
2.4 Installing the Wind Ring, Weighing Platform on Models EX124
Note: Assembly instructions also apply to models with the suffix M or N.
1. Place the Wind Ring in position.
2. Insert the Platform Assembly onto the Mounting Cone
located in the center of the Balance.
2.5 Installing the Sub-Platform and Weighing Pan on Models EX223
EX1103
1. Place the Sub-platform in position.
2. Position the Platform on the Sub-platform.
2.6 Installing the Weighing Pan on Models EX12001, EX24001 and EX35001
1. Position the Platform on the base.
1
Notes: Includes Automatic draftshield door Model
2
Includes ExCal Model
2.7 Installing the Draft Shield Glass and Doors on Draft Shield Models
1. Carefully remove each of the four glass Draft Shield sections from the packaging.
NOTE: Before installing side doors, be sure to set the lock tabs in the proper position, as shown here.
UNLOCK:
2. Follow the steps below to install side, front and top doors of the Draft Shield.
LOCK:
EXPLORER BALANCE
1 1
, EX224 and EX324
2 2
, EX423 , EX623 and
1