Installation Instructions; The Room; Flue; Mounting And Installation - FRANCO BELGE Lorraine Manual De Instrucciones

134.10.02 Lorraine Wood stove

2. Installation instructions

Stove base

2.1. The room

Ventilation :
For satisfactory operation with a natural draught, check
that sufficient air for combustion is available in the room.
Chimney position :
Heat shield
Leg
For new chimney installations, select a central position
within the building, to provide a good heat distribution
Bolt
around the building.
Hearth :
The hearth must be suitable for use with solid fuel burning
appliances and must comply with Current Building Regula-
tions. If in doubt, consult your Dealer or local Building
Fig. 3 - Installation of legs and lower heat shield
Inspector.
Rear wall and ceiling :
The appliance must not be positioned close to combustible
materials, wall & ceiling surfaces etc., Consult your Dealer
or local Building Inspector if in doubt.

2.2. Flue

Existing flue :
- The flue must be in good condition and must provide
sufficient draught.
- The flue must be suitable for the installation of solid fuel
burning appliances and comply with Current Building Re-
gulations.
- The flue must be clean. It should be swept to remove soot
and dislodge tar deposits.
- The flue must be well insulated. If the flue inner wall
surfaces are cold, a good thermal draw is impossible cau-
sing condensation problems (tar formation etc).
- The flue must not be shared with other appliances.
- The recommended minimum flue height is 5 metres.
- If the chimney has any down draught tendency, due to its
position in relation to nearby obstacles, an anti-down
draught cowl must be installed on the chimney or the
Fig. 4 - Removal of cast iron top
chimney height must be increased.
- If the decompression in the chimney is excessive, a
draught stabiliser must be installed.
Chimney to be built / Flue non-existent :
- The stove must not support the weight of the flue.
- Consult a chimney specialist for advice on suitable flue
systems for solid fuel appliances.

2.3. Mounting and installation

To avoid damage during transport, the four legs and the
bottom heat shield are not mounted when the stove is
shipped from the factory. These parts should be fitted
carefully to avoid damaging the appliance.
Fig. 5 - Smoke exit from top
14 Document n° 89-4EN~ 02/11/1998 Technical manual