Craftsman 30927 Instrucciones Para El Usuario

User Instructions
ROUTER GUIDE KIT
MODEL NO. 30927
Safety Warning:
Always wear safety glasses or eye shields
before commencing power tool operation. Follow your manufac-
turer's instructions for safety when using this attachment. Always
keep hands at a safe distance from spindles and cutting tools.
Always disconnect power source before working with power tools.
ASSEMBLING CIRCLE / EDGE GUIDE
Check the parts in your box against the parts list. If there are any
missing parts, please call 815-874-2400 and ask for the Sears
service area.
To assemble with the Edge Guide or Center Pivot Slide:
1. Attach the aluminum beam (Fig.1) to the Circle/Edge Guide
head. Ensure the beam is fully inserted into the head and
knobs are tightened securely.
2. Attach the Edge Guide (Fig.2) to the aluminum beam.
Fig. 1
3 Attach the Center Pivot Slide
.
(Fig.3) to the aluminum beam.
Assemble the Pivot Slide with
the arm facing the Circle/Edge
Guide head. The arm can be
inverted for larger diameter
cuts.
Note: The Edge Guide and
Center Pivot Slide should not be attached to the aluminum
beam at the same time.
ASSEMBLING TURNLOCK™ BASE PLATE TO ROUTER
1. Remove power source from router
2. Remove existing base (Fig.4) from router by removing appro-
priate screws/bolts.
3. Hold the Base Plate (Fig.5) so that the screw mounting area is
facing away from the router.
Fig. 4
Sears, Roebuck and Co., Hoffman Estates, IL 60179, U.S.A.
www.craftsman.com
Fig. 2
Fig. 3
Fig. 5
4.Rotate the Base Plate (Fig.6) over the router's threaded screw
holes until the correct alignment is found.
5.Loosely fasten the Base Plate (Fig.7) to the router by installing
the same screws/bolts removed in step 1.
Fig. 6
6.Install the appropriate end of the
centering pin (Fig.8) to the router
collet. (Follow your router manu-
facturer's instructions for this
step.)
CENTERING TURNLOCK
BASE PLATE
1. Install the provided TurnLock
Bushing (Fig.9) on to the Base
Plate by twisting into the TurnLock opening in the center of the
base.
2. With the base plate in contact with the centering pin, adjust
as needed to center the TurnLock Bushing on the centering
pin (Fig. 10).
Fig. 9
3. When centered, secure the Base Plate into position (Fig.11)
by tightening the appropriate screws/bolts.
4. Remove the TurnLock Bushing from the Base Plate (Fig.12)
by twisting out of the TurnLock mechanism.
Fig. 11
5. Remove the centering pin
(Fig.13) from the router
collet. (Follow your router
manufacturer's instructions
for this step.)
Your TurnLock Router Base Plate
is now installed and centered.
To use, simply twist desired
Bushing into place. Follow router
manufacturer's guidelines for proper router operation.
Fig. 7
Fig. 8
Fig. 10
Fig. 12
Fig. 13