Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Top Grille Panel – Routing Requirements
Top and bottom edges of the top panel should be edge routed
¹⁄₂ in. (1.3 cm) and ³⁄₈ in. (9.5 mm), respectively. Both ends should
be edge routed ⁷⁄₈ in. (2.2 cm) as shown.
1
/
"
4
(6.35 mm)
max.
Top
Grille
7
/
"
8
(2.2 cm)
NOTE: When creating a panel with face detail, the offsets will be
hidden and must be accounted for in order to center the detail in
the top grille.
1
/
"
2
(1.3 cm)
min.
Center face
detail between
offsets
3
/
"
8
(9.5 mm)
min.
1
/
"
4
(6.35 mm)
max.
Top
Grille
7
/
"
8
(2.2 cm)
1
/
"
4
(6.35 mm) max.
1
/
"
4
(6.35 mm) max.
Door Panels – Routing Requirements
If an extended handle kit is used, then routing the handle side of
the panels is not required. See "Handle and Door Clearances" for
more information on ordering extended handles.
If the standard handle is used, route the entire handle side of
both panels 3¹⁄₄ in. (8.25 cm) to allow for finger clearance. Then
route the other sides 1 in. (2.54 cm).
Standard Handle – Top View
3
1
/
"
4
(8.25 cm)
min.
1
/
" (6.35 mm) max.
4
2" (5 cm)
min.
Door Panel - Side View
1
/
" (1.3 cm)
2
Hinge Side
Door
Door
Panel
Panel
(2.54 cm)
1
/
"
4
(6.35 mm)
max.
min.
1"
11
Publicidad
Tabla de contenido
