Publicidad
Idiomas disponibles
Idiomas disponibles
INS_800-2380-0_MM3-Bi.qxd
5
All manuals and user guides at all-guides.com
5/16/08
2:16 PM
Page 6
Connector
Step 5: Holding the front housing secure, slowly lift the rear housing
Step 6: Pull reflector away from rear housing carefully. Do not touch
Note:
Step 7: Rotate the inner reflector bracket to OPEN position.
Step 8: Pull inner reflector bracket away from rear housing being
Figure 2
Step 9: Disconnect bulb wire from connector by holding the connector
Step 10: Pinch the ends of the wire retainer together and lift up as
Step 11: Pull bulb straight out from the reflector mounting plate.
Step 12: Disconnect bulb wire from connector by holding the connector
Step 13: To install new bulb, grasp the bulb from the metal end (DO NOT
Figure 3
Step 14: Replace wire retainer by pinching ends together while pressing
Step 15: Reconnect the bulb wire to the connector as illustrated
Step 16: To reassemble, rotate the inner reflector bracket to CLOSE
Step 17: Replace the two screws that were removed in Step 3. Do not
Replacement bulbs may be purchased from The Brinkmann Corporation
Customer Service Department by calling 800-468-5252.
Figure 4
off.
the inside of reflector.
The glass lens is not attached to front housing. Use care when
disassembling to avoid breaking lens.
careful not to pull wire connections inside. Do not touch the
inside of reflector.
firmly with fingers then pulling bulb wire straight out as shown
in Figure 2.
illustrated (Figure 3).
firmly with fingers then pulling bulb wire straight out.
TOUCH THE GLASS PART) and insert into the reflector
mounting plate. Align the slots in the bulb base with those in
the reflector mounting plate.
down. Push ends apart so they catch on the reflector mounting
plate.
(Figure 4).
position. Place the front housing face (lens) down on a flat
surface. Set the reflector into housing. Insert the rear housing
into the front housing of the spot/flood light.
over tighten screws.
Publicidad
