Using The Remote Control - Human Touch Super Novo Manual De Uso Y Cuidado

get acquainted

USING THE REMOTE CONTROL

The status screen displays during your massage, providing a quick reference for the following information.
This handy display not only shows the current status for each of the settings, but allows you to configure the
settings in the upper left-hand corner of the screen. Use the up/down navigation buttons to toggle through
the settings; use the right/left buttons to adjust them.
SPEED — In manual mode, the
Kneading, Tap Touch, Percussion, or
Knead & Percuss speed
CLOUD TCH — The Cloud Touch
intensity (Cloud Touch must be active to
set the intensity)
FOOT SPD — The underfoot roller speed
(rollers must be on to set the speed)
WIDTH — In manual mode, the Tap
Touch, Percussion, or Shiatsu horizontal
massage range
3D — The back massage intensity (not
configurable during Meditation programs)
The amount of time remaining in
the current massage session
Illustrates the areas currently
being massaged
humantouch.com
The active massage program
Lights blue when Bluetooth is set to On
Lights blue when chair is in ZeroG position
The active robotic massage technique
Vertical massage range indicator:
- Full
- Zone
- Spot
Lights red if heat is on
8 8
MENU — Displays the main menu.
Press twice fast to go back a screen.
AUTO — Displays the AUTO
programs menu. When an
auto program is running,
press to toggle among the
auto programs. The active
program displays at the top of
the status screen.
CLOUD — When the status screen
is displayed, press to adjust the
Cloud Touch intensity. The selected
intensity displays in the upper left-
hand corner of the screen.
BACK — Press and hold to
recline or incline the backrest.
LEGS EXTEND — Press and hold
to extend the footrest.
NOTE: During auto programs,
your leg length is automatically
measured and the program
adjusted accordingly.
ON/OFF — Press this button:
• To power on the remote.
• Select STOP to stop your massage immediately.
• Select POWER OFF, then select RESTORE
to return the chair to the upright position
before exiting.
Press the up/down/left/right buttons to
navigate the screens; press the center
button to select an option.
POSITION — Use to move the massage rollers
to the desired position when enjoying a Zone
or Spot massage. See Using Manual Massage
Modes on page 16 for more information.
HEAT — Press to toggle the backrest and
footrest heat on and off.
LEGS — Press and hold to raise or lower
the footrest.
ZeroG — Press and hold to automatically
®
position the chair in ZeroG mode, raising
your feet above your heart for maximum
spine relief.
LEGS RETRACT — Press and hold
to retract the footrest.
If the chair is not in use for three minutes the
controller display automatically shuts down.
Press the ON/OFF button to resume use.
The chair resets all settings to the default position.
9