Ezviz Lc1 Guía De Inicio Rápida página 6

Step4
Mount the security light camera to the base plate
1. Plug the 3-wire connector back into the security light camera as shown. Make sure it's completely
seated before proceeding.
Step5
Connect the junction box and the base 3-wire connector
1. Match each color wire from the base plate to the same color from the junction box (blue to blue, yellow-
green to yellow-green, brown to brown).
Step6
Turn on power to your security light's circuit.
2. Fix the security light camera to the base plate with base screws.
2. You may use the wire connector for special junction box, then connect the wires as below.
Brown
L
Yellow-green
Blue
N
IP65 Junction Box
*Purchased Seperately
Put the ends of each pair into the wire connector, then twist it tightly.
Step7
At first power up, the security lights turn on. when the security lights turn off and the LED indicator on the front
of the camera flashes blue, the security light camera is ready for setup.
3
Confirm the security light camera has power
LED Indicator
Brown
L
Yellow-green
Blue
N
IP65 Junction Box
*Purchased Seperately
If you've installed the security light
camera on a switchable outlet, make
sure you turn the outlet on and leave
it on for the security light camera to
function 24/7.