Using The S8 Escape Ii; Set Up The S8 Escape Ii - ResMed S8 Escape II Guia Del Usuario

Using the S8 Escape II

WARNING
!
Make sure the power cord and plug are in good condition and the
•
equipment is not damaged.
Only ResMed air tubing should be used with the device. A different type
•
of air tubing may alter the pressure you actually receive, reducing the
effectiveness of your treatment.
Blocking the hose and/or air inlet of the device while in operation could
•
lead to overheating of the device.
CAUTION
!
Be careful not to place the device where it can be bumped or where
•
someone is likely to trip over the power cord.
If you put the device on the floor, make sure the area is free from dust
•
and clear of bedding, clothes or other objects that could block the air
inlet.
Make sure the area around the device is dry and clean.
•

Set Up the S8 Escape II

1
Connect the power cord to the socket at the rear of the S8 Escape II.
2
Plug the other end of the power cord into the power outlet.
3
Connect one end of the air tubing firmly onto the air outlet.
4
Connect the assembled mask system to the free end of air tubing.
For information on assembling your mask, see your mask manual.
1
3
2
4
Using the S8 Escape II 3