Rainbow SRX Manual Del Propietário página 12

Troubleshooting Guide
This Rainbow appliance has been thoroughly tested and inspected. If a minor issue develops, the following troubleshooting procedures may help identify and correct the
matter. If you are unable to resolve the issue, contact an Authorized Rainbow Distributor for service. Any service procedure not listed below should be performed by an
Authorized Rainbow Distributor or Service Center.
WARNING:
!
Disconnect electrical supply before performing any maintenance to the unit. Failure to do so could result in electrical shock or personal injury.
ISSUE
The Rainbow motor is not running
Noticeably reduced airflow
Unit discharges dust
Heavy foaming in water basin
11 |
R A I N B O W S R X
POSSIBLE CAUSE
Rainbow not properly latched to water basin
Not firmly plugged in
Timer mode has ended (all three timer lights will blink)
None of the above
Plugged hose, wand, attachment or Power Nozzle
HEPA Neutralizer needs servicing or replacement
Rainbow is running on low speed
Separator is clogged or dirty
Low level of water in basin
Excessively dirty water in basin
Hole in HEPA Neutralizer
Soapy contaminant in water basin
POSSIBLE SOLUTION
Ensure Rainbow is properly seated and latched onto water basin
Plug unit in firmly or try another outlet
Turn unit off with main power switch
Contact an Authorized Rainbow Distributor or Service Center
Remove obstruction from clogged area
Remove HEPA Neutralizer and clean or replace
Increase the airflow using 4-Level Airflow Control
Remove separator and clean (See page 8)
Fill water basin to correct level
Replace with clean water
Contact an Authorized Rainbow Distributor or Service Center
Replace with clean water