Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
Remove shipping materials, tape, and film from range.
Keep shipping pallet under range. Remove oven racks, and parts
package from inside oven. Remove grates from top of oven.
Remove Kick Plate
1. Your range will have the kick plate packaged on top of the
unit.
a. Remove kick plate from top of range and grate pack.
In packaging
A. Kick plate
Packaging removed
A. Kick plate
b. Lay kick plate to the side to avoid scratching.
INSTALLATION INSTRUCTIONS
Unpack the Range
A
A
2. For 48" (121.9 cm) models only, rotate center support
counterclockwise off the pallet until it stops.
NOTE: This support is used only for shipping and is not
needed for installation.
3. Lay a piece of cardboard from packaging on the floor behind
range. Using two or more people, firmly grasp each side of
range. Lift range up about 3" (8.0 cm) and move it back until
range is off shipping pallet. Set range on cardboard to avoid
damaging floor.
Remove Door
Door Removal
Do not remove the side door spacers until the range is ready
■
to install. Removing the door spacers could allow the door to
shift, damaging the door latch.
Do not lift or move the range by the door handle(s) or control
■
panel.
Prior to installing the range, you will need to remove the oven
■
door(s). Prepare a surface where you will place the door(s).
This surface should be flat and covered with a soft blanket,
or use the corner posts from the packaging material.
A. Oven door hinge in the locked position
B. Oven door hinge in the unlocked position
A
B
9
Publicidad
Tabla de contenido
