OZ Lifting Products OZ1000BW Manual Del Operador página 10

Take note of the following regarding inspections.
• Brakes require more than audible and visual inspection. Check daily by operating with and without a load,
stopping at various positions to ensure safe operation. If the load coasts or creeps contact the factory for
friction disc replacements.
• Proper inspection may require disassembly of some parts. Contact the factory before doing so or the
applicable warranty may be voided.
• For wire rope inspections please contact the specific manufacturer of the rope. The inspection provided in
the chart below is for a general inspection only and is in no way the complete inspection required.
• Before operation assure all deficiencies on the inspection chart are resolved and inspections are up to
date. Refer to troubleshooting chart for further assistance.
Inspection Chart
Frequent Inspection (F) and Periodic Inspection (P)
Location
General
Foundation
Brake Assembly
Fasteners
Gears, bearings, shafts
Handle
End Connections
Drum
Load Hook
Frame
Wire rope
Labels
Check For
Paint chipping or excessive wear
Damage, cracks, rust, dents excess wear, or corrosion.
Unusual sounds
Smooth load movements
Winch lubricated
Signs of overloading (cracks, dents, or damage)
Proper function when operated with a load equal to the load rating
Good condition/Supports the winch under all conditions
Cracks, corrosion, damage
Ratchet pawl clicks firmly as handle is turned clockwise
Proper operation
Corrosion, cracks, damage, or wear
Firmly installed
Properly tightened
Stripped threads, bent, or damage (check by removing winch from the foundation)
Excess wear, cracks, corrosion, or damage
Well lubricated
Rotates freely in both directions
Corrosion, excess wear, rust, or damage
Attached firmly
Excess wear or distortion of anchor hole
Excess movement due to misaligned gears, bearings, shafts (check by moving the drum by hand)
Bent, twisted or damaged
Hook latch doesn't close when released
Securely attached to wire rope with no fraying or damage to the rope
Bent, cracks, or damage (signs of overloading)
Installed correctly
Wound tightly and evenly on drum
No visible damage to entire rope
Not been removed, altered, or obscured (Contact factory for replacements)
EN pg.10
F P
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X