Tabla de contenido
Publicidad
3
4
5
6
1.
2.
4 mm
English
Installation
Make sure that both stops are
closed.
Cut the plaster shield so that it extends ¹⁄₁₆" -
⅛" from the finished wall surface.
Seal the wall around the
plaster shield with waterproof
sealant (1).
Failure to seal the wall can lead
to possible water damage.
Remove the flush insert screw using a 5 mm
Allen wrench (2).
Remove the flush insert and seals.
Insert the function block.
Install and tighten the function block screws
using a 4 mm Allen wrench.
Publicidad
Tabla de contenido
