Publicidad
TROUBlE ShOOTING
\
Problem
EN
Slices are slanted or uneven.
Some food remained on the
disc after processing.
The motor slows down
during operation.
The motor slows to start
with S-blade.
The motor does not work.
The food processor shuts
off during operation.
The food processor
vibrates/moves during
operation.
ElECTROlUx REPlACEMENT PARTS
Large Processing Bowl
Replacement parts
Bowl Lid (with Seal)
Bowl Lid Seal
Large Pusher (with Lid)
Small Pusher (with Lid)
Dough Blade
Whisk Disc
French Fry Disc
Reversible Shredding Disc
Adjustable Slicing Disc
Spindle (for dough blade and discs)
Large Slicing Blade
Small Slicing Blade
Small Processing Bowl
Accessory Storage Bag
To order replacement parts, visit us online at www.electrolux.com or call 1-888-845-7330.
18
www.electrolux.com
Possible cause
The food is light, it jumps during
slicing.
It is normal for small pieces to remain
after processing.
Amount of dough may exceed
maximum capacity.
Dough may be too wet, it sticks onto
the side of the bowl.
Amount of meat may exceed
maximum capacity.
Too much fat in the meat.
There is a safety interlock switch to
prevent the motor from starting if it
is not properly assembled.
The appliance is not connected to
the electrical outlet.
The lid may have become unlocked.
The rubber feet are wet.
It is normal for heavy loads
(e.g heavy dough, cheese).
Solution
Load food in the filler hole. Place big /
small pusher onto food and apply
pressure. Then start.
Always clear any blocked food from
chipper disc by yourself.
Remove half and process in two batches.
Add more flour, 1 tablespoon at a time
until the motor speeds up. Process until
dough cleans the side of the bowl.
Remove the meat and process in
two batches.
Note that for best result trim the meat of
fat before processing.
Make sure the processing bowl, lid are
securely locked into position. Make sure
that the large pusher is correctly placed
into the large feeding tube.
Make sure to plug in the appliance
before operation.
Check to make sure it is securely in
position.
Make sure the rubber feet at the bottom
of the unit are clean and dry.
Remove half and process in two
batches.
SPA285004
Part number
SPA285003
RUB285001-020G00
SPA28500
SPA285001
PLA285024-010A01
PLA285045-001A01
SPA285008
SPA285009
SPA285011
SPA285006
SPA285005
SPA285007
PLA285002-013B01
SPE285003
Publicidad
