La-Z-Boy PowerRecline Instrucciones De Operación página 7

La-Z-Time PowerRecline Motion-Modulars
®
Assembly Instructions
WARNING
– To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area rugs
at a distance to allow the legrest to fully extend without rubbing or interference.
7. Adjustable glides are standard on units with metal base rails. Adjust the glides to a height that
provides an unobstructed path for operation of the legrest (see Furniture Placement Guide).
Each glide is attached to the base rail by one jam nut and one lock washer on top of the front
•
attachment bracket, and one jam nut on the bottom of the base rail (F
unit featured). Loosen the jam nut located on top of the front attachment bracket.
Holding the top jam nut, turn the glide clockwise to lower the unit or counterclockwise
•
to raise the unit.
Tighten the bottom jam nut to the base rail, then tighten the top jam nut to the lock washer on top
•
of the front attachment bracket. Make sure both jam nuts are tight to prevent the bracket from
rotating on the base rail.
Repeat this step for each adjustable glide, if necessary.
•
8. Identify the electrical components to be used in the following assembly steps (F
vary by style; units with lighted cup holders have additional connections.
9. Locate the motor connector behind the power motion-modular unit (F
with a lighted cup holder proceed to step 12
10. Connect the power supply to the motor connector (F
11. Connect the 120 volt power cord to the power supply (F
in the Operating Instructions. Proceed to step 15 for units without lighted cup holders.
12. Connect the small Y-cable to the motor connector and lighted cup holder connector behind the
power motion-modular unit (F 12).
IGURE
13. Connect the power supply to the small Y-cable (F
14. Connect the 120 volt power cord to the power supply (F
instructed in the Operating Instructions.
15. To remove the backs, unplug the 120 volt power cord from the electrical outlet and disconnect
the power supply from the motor connector behind the power motion-modular unit.
Reverse the Assembly Instructions steps.
F 7
IGURE
Upper Jam Nut
Front
Attachment
Bracket
Lower
Jam Nut
Adjustable
Glide
(PowerRecline Motion-Modulars Assembly Instructions Continued)
12
7, Motion-Modular
IGURE
8). Components
IGURE
9). If assembling a unit
IGURE
10).
IGURE
11). Do not plug in until instructed
IGURE
13).
IGURE
14). Do not plug in until
IGURE
Lock Washer
Base Rail
La-Z-Time PowerRecline Motion-Modulars
®
Assembly Instructions
F 8
IGURE
PowerRecline Units Without PowerRecline Units With
Lighted Cup Holders Lighted Cup Holders
Power 120 Volt Power
Supply Power Cord Supply
F 9 F
IGURE IGURE
Motor Lighted Cup Holder Power
Connector Connector (select Supply
units only)
F 12 F
IGURE IGURE
Make these
connections
Make this
connection
Motor Small Cup Holder
Connector Y-Cable Connector
120 Volt Small
Power Cord Y-Cable
10 F 11
IGURE
Make this Make this
connection connection
Motor 120 Volt
Connector Power Cord
13 F 14
IGURE
Power Small Power
Supply Y-Cable Supply
Power
Supply
Make this
connection
120 Volt
Power Cord
13