Troubleshooting; Furniture Placement Guide - La-Z-Boy Power Recline Instrucciones De Operación

La-Z-Time Power Motion Sofas &
®
Power Motion-Modulars
WARNING
– To reduce the risk of serious injury:
• Do not attempt to disassemble or service the pump or motor; no serviceable parts are
inside. Contact your La-Z-Boy dealer for service.
®
• Check the condition of the power transformers, electrical cords, plugs and connectors
monthly. Keep the power transformers and electrical cords away from heat sources.
Never operate the unit with a damaged power transformer, electrical cord, plug or
connector. Contact your La-Z-Boy
• The La-Z-Time Power units are intended for a single occupant, not exceeding 300 pounds
per seat. Do not operate individual seats or units with more than one occupant in or on
any part of the individual seat or unit.
If the legrest stops moving while closing, it may have disengaged from the mechanism.
Check the following:
Make sure the legrest did not contact an obstruction while closing. Remove any obstruction
1.
from the legrest path.
Firmly push the legrest closed with your legs. You will hear a "pop" when the legrest
2.
is reconnected to the mechanism; refer to the Operating Instructions.
To prevent damage to the safety mechanism, do not attempt
NOTICE:
to reengage the legrest when it is in the fully open position.
If the power recliner does not work, check the following:
1. Make sure the 120 volt power cord is plugged into an electrical outlet.
Make sure the electrical outlet is working. For example, make sure there are no blown
2.
fuses or tripped circuit breakers.
3. Make sure all the connectors are secure; refer to the Assembly Instructions.
Make sure the electrical cords are not crimped or pinched. Make sure the electric cord
4.
or plug is not damaged.
Make sure the operating capacity has not been exceeded and there is only one occupant
5.
in the individual seat or unit; refer to the Operating Instructions.
If the power recliner still does not operate properly, contact your dealer for instructions
on returning the unit for examination and repair.
18
®

Troubleshooting

® dealer for service.

Furniture Placement Guide

WARNING
– To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area rugs
at a distance to allow the legrest to fully extend without rubbing or interference.
To place your reclining unit the proper distance from the wall, fully recline the unit and leave
a minimum of 2" of space between the top of the back and the wall.
Place tables and area rugs at a distance to allow the legrest to fully extend without rubbing
or interference. If necessary, raise the adjustable glides to prevent the legrest from rubbing or
interfering with area rugs; refer to the Assembly Instructions.
2" Min.
19