Publicidad
Idiomas disponibles
Idiomas disponibles
Service Instructions
WARNING:
WARNING:
Each component used in your dryer has been designed to provide years of trouble‑free service. However, if trouble
should develop, it can normally be located by visual examination. Removal or replacement of most parts is simple and
can be done without special tools.
IF THE DRYER WON'T TURN ON:
Check electrical service, circuit breaker. Make sure proper voltage is being supplied to the dryer. Check for loose or
disconnected terminals to sensor. INCREASE sensitivity (F
and into the pot to CAREFULLY turn the adjustment pot located on the sensor CLOCKWISE 1/3 turn MAX. If necessary,
replace sensor.
IF DRYER WILL NOT SHUT OFF:
Make certain black foam is attached to lens and lens is clean. If damaged, replace. DECREASE sensitivity (F
inserting a flat‑blade screwdriver through the hole and into the pot to CAREFULLY turn the adjustment pot located on
the sensor COUNTER‑CLOCKWISE, 1/3 turn MAX. If necessary, replace sensor.
CPC AND GXT ONLY - IF COLD AIR IS COMING FROM THE NOZZLE:
Turn off breaker for 30 seconds to reset thermostat. If necessary, inspect heating element by unfastening blower housing
from backplate (3 screws). Remove heating element from blower housing to inspect for damage. Replace if necessary.
IF NO AIR IS COMING FROM THE NOZZLE:
If the dryer also trips the circuit breaker, replace the motor/blower assembly by unfastening the blower housing from the
backplate (3 screws) and remove the inlet shield. Otherwise, replace the sensor.
COLD PLASMA GENERATOR:
The cold plasma generator is maintenance free. There are no chemicals to refill and no filters to change.
All parts of the
X
e
treme
material workmanship for a period of five (5) years from the date of purchase from the manufacturer. All models
outside of the U.S.A. one (1) year. We will replace, during the warranty period, any warranted part which proves
defective in material and or workmanship under normal installation, use, and service, excluding normal wear.
Replacement parts can be obtained by returning the part, TRANSPORTATION CHARGES PREPAID. You must
notify factory prior to returning part or dryer. Any damage to this dryer as a result of misuse, abuse, neglect,
accident, improper installation, unauthorized repairs, or any other use violative of instructions furnished by us
WILL VOID THIS WARRANTY. THIS LIMITED WARRANTY IS THE SOLE WARRANTY ON OUR PRODUCTS, AND
WE DISCLAIM AND EXCLUDE ANY AND ALL OTHER WARRANTIED, EXPRESS OR IMPLIED, INCLUDING ANY
IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. OUR LIABILITY SHALL
NOT EXCEED IN ANY EVENT THE REPLACEMENT OR SALE PRICE OF THE ALLEGEDLY NONCONFORMING
PRODUCT AND SHALL EXCLUDE LABOR CHARGES. TO THE EXTENT PERMITTED BY LAW WE SHALL NOT BE
LIABLE FOR ANY LOSS, COST, EXPENSE, OR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY KIND.
WHETHER BASED UPON WARRANTY (EXPRESS OR IMPLIED), CONTRACT, NEGLIGENCE OR STRICT LIABILITY
AND ARISING IN ANY WAY IN CONNECTION WITH THE DESIGN, MANUFACTURE, SALE, USE OR REPAIR OF
THE PRODUCT.
Disconnect Power Before Servicing
Installation Shall be Performed by a Qualified Licensed Electrician
X
A
e
treme
models are warranted to the original consumer purchaser to be free from defects in
A
ir
3) by inserting a flat‑blade screwdriver through the hole
igure
LIMITED WARRANTY
ir
3) by
igure
Publicidad
