Wheels P; The Frame; Push Bar; Brake P - Mutsy trans range Manual De Instrucciones

English
- 1 seat with hood
- 4 wheels (2 front and 2 rear)
assembly sequence:
- Fold out frame
- Assemble rear wheels
- Assemble front wheels
Wheels
assembly and dismantling of the rear wheels
· Two rear wheels are to be fitted to the
frame. The rear wheels include a brak-
ing rim.
· The central cap on the wheel must be
depressed to allow the rear wheel to be
fitted, after which the wheel axle can
be pressed into the tube. The cap is
then released, and if a click is heard
the wheel is correctly fitted. (A1)
· The rear wheels are removed by press-
ing in the central cap and removing the
axle from the tube. (A2)
assembly and dismantling of the front
wheels
· In order to install the front wheels the
vertical wheel axle is inserted in the
swivel housing on the frame. Push the
wheel into the wheel tube. When the
wheel has been inserted as far as pos-
sible into the wheel tube, press on the
round cover cap above the wheel tube.
The wheel is now locked in place. (B1)
· The front wheels are removed by press-
ing in the round button above the wheel
and pulling the wheel axle out of the
tube. (B2)
Front wheels to swivel mode
· Move the pedal levers on both wheel
forks upwards. (C1) The front wheels
will now swivel.
· Locking the swivel system: Move
the pedal levers on both wheel forks
downwards. (C2) The wheels will now
12
lock when they are returned to their
original straight-ahead position.

The frame

Folding out the frame
· Apply the brake or place a foot on the
rear axle.
· Move the upper frame upwards (D1) un-
til a click is heard. (D2)
· Press in the buttons on the sides of the
handle grip. (D3)
· Twist the handle grip upwards and re-
lease the button when the push bar is
in the desired position. (D4)
! Before each use, check that the strol l er
is correctly unfolded and locked.
Folding the frame
· Apply the brake or place a foot on the
rear axle.
· Press in the buttons on the sides of
the handle grip and twist the grip to
place it in its lowest position. (E1)
· This position is indicated by the circle
marked on the hinge point. (E2)
· Pull the unlocking slides on the inner
side of the frame towards you (E3)
and press down on the frame. (E4)

Push bar

· The push bar can be adjusted be-
tween four pushing positions and a
folded position.
· Press in the buttons on the sides of the
handle grip to make these adjustments.
· With the buttons pressed in, the han-
dle grip can now be moved to the de-
sired position. (F)
Brake
· Gently move the brake rod (in front of
the rear axle) downwards with the foot
to apply the brake.
· Move the brake rod (in front of the rear
axle) upwards to release the brake. (G)